Phoenix Machines

1 Reviews

0.0000 stars - based on 1 reviews
34 Henry Nix Rd Cleveland, Georgia 30528
(706) 219-3799
 
 

About

Phoenix Machines is located at the address 34 Henry Nix Rd in Cleveland, Georgia 30528. They can be contacted via phone at (706) 219-3799 for pricing, hours and directions.

Phoenix Machines has an annual sales volume of 501K - 999,999. .

For maps and directions to Phoenix Machines view the map to the right. For reviews of Phoenix Machines see below.

Information

CONTACT INFORMATION

Phone: (706) 219-3799

ADDITIONAL INFORMATION:

Employee Size: 1 To 4

Exact Employee Count: 1

Exact Sales Volume: 42000

Location Type: Single Location

Sales Volume: 501K - 999,999

CATEGORIES:

People Also Viewed

The Sign Shop

2109 Highway 129 S Ste A E Ste Cleveland, Georgia 30528
Reviews
Add
You must Sign in to post reviews.

by on

by Rob Freeman on 1/30/2018

Poor Quality, Not Professional.

I am a Machinist of 33+ years. The machines are NOT maintained, or serviced. These machines are Decades old, and constantly have problems. There was NO way oil in the reservoir, there was NO Hydraulic fluid in the machine, and the machine was 20 gallons low on coolant. When I watched the machine cycle through a part, I noticed that none of the coolant nozzles were on the cutters, or part being machined. The boss (Owner) consistently had a very poor attitude, very angry, and disrespectful towards his employees; He also employs a couple of people Under the Table there. (Off the Books) On the Manual mills, you cannot trust the Gaging, or the X/Y axis on that machine. (This is the Nice machine) The D.R.O. constantly goes out, or moves Several Thousandths of an inch. Way out of the stated Tolerances listed on the Blueprint. I showed the boss these parts that did NOT pass, and he told me not to worry about it. I am also a Quality Technician, and I KNOW what will work in machining. These parts did not pass, plain & simple. Now its the customer getting an expensive part, that will not work. Yes, he did ship those parts to the customer. The customer DID send them back, like I knew he would. A Great shop to look at is Meadowbrook Machine & Tool, in Estanollee, Ga. They have been in business for Decades, they are constantly growing, The shop is immaculate, climate controlled, and the people there are Sharp & Friendly. The machines there are new, clean, & maintained. They are also ISO approved. The machine work there can be trusted to the Millionths of a inch. Don't waste your Hard Earned Money at Phoenix Machines. Their Business cards aren't even printed straight. If they don't care about a card that represents their business, that should tell you about the Quality of their machines, and the work coming from that shop. I would give this shop a "NO Stars" if I could. The Better Business Bureau should know about this place. I must repeat, because of the other reviews here: The boss (Owner) consistently had a very poor attitude, very angry, and disrespectful towards his employees. When my last paycheck was sent to me, the Owners wife wrote: "Kiss my Ass". She was upset because I was UNDERPAID $180. and I had to argue with them for over a Month, before they finally paid me. DO NOT USE THIS SHOP.

1 Reviews